Update to Coat/Hat Racks

I thought I should post an update since I have been spending a lot of time making drawer pulls and Coat/Hat Racks. I’ve made a few more that I wanted to share with you. The first two are 3D printed bases that are covered with polymer clay cane slices. I dipped them in polyurethane a couple of times added some gold leafing and dipped again about 4 more times. I love the depth that is created by the multiple coats of polyurethane. Each coat has to dry at least 2 hours, so this can take a lot of time. Of course most of that time is spent literally watching the paint (polyurethane) dry.

3D Printed blank covered in polymer
3D Printed blank covered in polymer
Celestial-wooden ball covered in polymer

3D printed blank covered in polymer

2 thoughts on “Update to Coat/Hat Racks

  1. erotik

    This piece of writing will help the internet visitors for setting up new web site or even a blog from start to end.| Eadie Amerigo Evangelina

    Reply
  2. bursa escort

    Sed id tincidunt sapien. Pellentesque cursus accumsan tellus, nec ultricies nulla sollicitudin eget. Donec feugiat orci vestibulum porttitor sagittis. Corenda Vanya Ralli

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *